Brake Rotor, Replacing, Brake Pads Removed: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -arrow- and tighten.

Fig 1: Identifying Brake Disc Secure Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Install the rear brake carrier. Install and tighten the bolts -16 and 17-.

Fig 2: Overview Of Rear Brake Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To tighten the lower bolt -16-, use a commercially available extension. For the upper bolt -17-, no extension is required. Slightly move the wheel housing liner away.

-- Install the rear brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the combination bracket on the stub axle carrier so that the brake hose does not come out of the bracket on its own.

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.