Brake Rotor, Replacing, 1LT And 1LY: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the vehicle.

-- Remove the wheels.

-- Remove the front brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

Do not let the brake caliper hang from the brake hose. Secure it to the body with suitable cable ties or wire. Do not support the weight with the brake hose.

-- Remove the bolts -5- on the front brake carrier.

Fig 1: Overview Of Front Brakes Components (1LT And 1LY)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front brake carrier.

-- Remove the bolt -arrow- on the brake rotor while holding the brake rotor firmly.

Fig 2: Identifying Brake Disc Secure Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake rotor.

NOTE:

When removing the brake rotor from the wheel hub, do not tilt the brake rotor.