Brake Rotor, Removing And Installing, 1LM: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the bolts -1 and 13-.

Fig 1: Overview Of Front Brakes Components (1LM)

Courtesy of AUDI OF AMERICA, LLC

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the new bolt -1- and tighten it to 9 Nm.

Fig 2: Overview Of Front Brakes Components (1LM)

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LM .

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After the first drive, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.