Brake Pads, Removing And Installing, 1LT And 1LY: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the vehicle.

-- Remove the wheels.

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

-- Remove the caps -13-.

Fig 1: Overview Of Front Brakes Components (1LT And 1LY)

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.

-- Lift the securing strap slightly at bottom of connector and then rotate 90°.

-- Remove the lower part of the brake pad wear indicator connector from the bracket.

-- Using the screwdriver, pry off the brake pad spring from the brake caliper housing and remove.

Fig 2: Identifying Brake Pad Retaining Spring From Brake Caliper Housing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove both guide pins -12- from the brake caliper.

Fig 3: Identifying Caliper Guide Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

Secure the brake caliper to the vehicle with a suitable wire. Do not support the weight with the brake hose.

-- Remove the brake pad from brake caliper housing or from the brake carrier.