Brake Caliper, Replacing, Ceramic Brakes 1LW

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Removing

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

Observe the direction of rotation when installing brake rotor -arrow on brake rotor- and installed location -left or right-

-- Raise the vehicle.

-- Remove the wheels.

-- Remove the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, CERAMIC BRAKES 1LW .

-- Remove the bolts -10-.

Fig 1: Overview Of Front Brakes Components, Ceramic Brakes (1LW)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake caliper.

installing

Replace bolts

-- Carefully slide the brake caliper over the brake rotor.

-- Install the bolts -10- and tighten to 196 Nm.

Fig 2: Overview Of Front Brakes Components, Ceramic Brakes (1LW)

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, CERAMIC BRAKES 1LW .

-- Remove the Brake Pedal Actuator VAG1869/2.

NOTE:

Only bleed the brakes on the wheel which had the brake caliper replaced.

-- If there is insufficient brake pressure, bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Install the wheels. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After inserting brake pads and before driving for the first time, press brake pedal strongly several times while parked so that brake pads are properly seated in their normal operating position.

-- Check brake fluid level, and fill if necessary.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.