Brake Caliper, Replacing, 1LT And 1LY: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the Brake Pedal Actuator VAG 1869/2 between the brake pedal and driver seat by pressing the brake pedal down at least 60 mm.

Fig 1: Brake Pedal Depressor VAG 1869/2 Inserted Between Brake Pedal And Driver's Seat

Courtesy of AUDI OF AMERICA, LLC

-- Raise the vehicle.

-- Remove the wheels.

-- Connect the hose from a bleeder bottle to one of the bleeder screws on the front caliper.

-- Open a bleeder screw on the front brake caliper to reduce the pressure from the brake system.

-- Close the bleed screw and tighten to 13 Nm.

NOTE:

Do not remove the Brake Pedal Actuator VAG1869/2.

-- Remove the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven.

The brake rotor is secured with a bolt.

-- Remove brake hose from brake caliper.

-- Remove the brake caliper from the vehicle.

-- Remove the bolts -5- on the brake carrier while holding the carrier securely.

Fig 2: Overview Of Front Brakes Components (1LT And 1LY)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake carrier.