Brake Caliper, Replacing, 1LT And 1LY: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Always use new bolts.

-- Position the brake carrier.

-- Tighten the brake carrier with new bolts -5-.

Fig 1: Overview Of Front Brakes Components (1LT And 1LY)

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake hose into the brake caliper and tighten.

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

-- Remove the Brake Pedal Actuator VAG1869/2.

NOTE:

Only bleed the brakes on the wheel which had the brake caliper replaced.

-- If there is insufficient brake pressure, bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After inserting brake pads and before driving for the first time, press brake pedal strongly several times while parked so that brake pads are properly seated in their normal operating position.

-- Check brake fluid level, and fill if necessary.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.