Brake Caliper, Replacing, 1LM: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the bolts -13-.

Fig 1: Overview Of Front Brakes Components (1LM)

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper with the new bolts -13- and tighten.

-- Install the brake hose -8- in the brake caliper.

NOTE:

Brake hose in brake caliper: 16 Nm.

Brake pressure line to brake hose: 16 Nm.

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LM .

-- Remove the Brake Pedal Actuator VAG1869/2.

NOTE:

Only bleed the brakes on the wheel which had the brake caliper replaced.

NOTE:

Bleed each brake caliper at both bleed screws.

Bleed screw tightening specification: 15 Nm.

-- If there is insufficient brake pressure, bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

CAUTION:

After the first drive, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.