LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 489 (Brake System - Mechanical Components (Sedan) (As Of 01.2014)) >> 46 Mechanical Components >> Front Brakes >> Brake Caliper, Removing And Installing >> Brake Caliper, Removing And Installing, 1LM >> Installing

Brake Caliper, Removing And Installing, 1LM: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Replace the bolts -13-.

Fig 1: Overview Of Front Brakes Components (1LM)
GWWA46-10160Courtesy of AUDI OF AMERICA, LLC

-- Carefully press the brake caliper with brake pads installed over the brake rotor.

-- Tighten the brake caliper with new bolts -13-.

-- Place the brake hose into the bracket.

-- Install the wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.

CAUTION:

After the first drive, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their normal operating position.

CAUTION:

Make sure the brakes are working correctly before driving the vehicle for the first time.

scientia non olet · About LEMON Manuals