LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 489 (Brake System - Mechanical Components (Sedan) (As Of 01.2014)) >> 46 Mechanical Components >> Brake Pedal >> Brake Pedal, Removing And Installing >> Brake Pedal, Removing And Installing, Vehicles With Manual Transmission

Brake Pedal, Removing And Installing, Vehicles With Manual Transmission

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

To remove the brake pedal on vehicles with a manual transmission, the mounting bracket must be removed.

-- Remove the mounting bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .

Remove the brake pedal on the removed mounting bracket.

-- Remove the bolt -3-.

Fig 1: Overview Of Brake Pedal (Vehicles With Manual Transmission)
GWWA46-10041Courtesy of AUDI OF AMERICA, LLC

-- Remove the retainer -1- on the left side and remove the pins -5- to the right.

Fig 2: Overview Of Brake Pedal (Vehicles With Manual Transmission)
GWWA46-10041Courtesy of AUDI OF AMERICA, LLC

-- Remove brake pedal.

Install the brake pedal on the removed mounting bracket.

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

Fig 3: Overview Of Brake Pedal Components
GWWA46-10110Courtesy of AUDI OF AMERICA, LLC
NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Do not destroy the brake pedal stop -17-. There is the danger that the brake lamp sensor mount -10- could break when the brake pedal is released.

-- Slide the right retainer onto the pins.

-- Slide the pins from right to left through the axle in the brake pedal.

-- Secure the pins with the left retainer -1-.

Fig 4: Overview Of Brake Pedal (Vehicles With Manual Transmission)
GWWA46-10041Courtesy of AUDI OF AMERICA, LLC

The pins must be secured with the retainers on both sides.

Fig 5: Overview Of Brake Pedal (Vehicles With Manual Transmission)
GWWA46-10041Courtesy of AUDI OF AMERICA, LLC

-- Install and tighten the bolt -3-.

-- Install the mounting bracket. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .