Brake Pedal, Removing And Installing, Vehicles With Automatic Transmission: Removing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the driver side instrument panel cover -1 to 3-.
-- Disconnect the connector -C- on the footwell vent.
-- Remove the footwell vent -A-.
-- Remove the brake lamp sensor. Refer to BRAKE LAMP SENSOR, REMOVING AND INSTALLING .
-- Separate the brake pedal from the brake booster. Refer to BRAKE PEDAL, REMOVING FROM BRAKE BOOSTER .
WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
-- Remove the bolt -11-.
-- Remove the retainer -5- and remove the pins -4- to the left.