Brake Pedal, Removing And Installing, Vehicles With Automatic Transmission: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Do not destroy the brake pedal stop -17-. There is the danger that the brake lamp sensor mount -10- could break when the brake pedal is released.

-- Slide the left retainer -12- onto the pins.

-- Slide the pins from left to right through the axle in the brake pedal.

-- Secure the pins with the right retainer -5-.

Fig 2: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

The pins must be secured with the securing clips -5 and 12- on both sides.

-- Install the bolt -11- and tighten.

Clip the brake pedal to the brake booster.

-- Hold the ball head of pushrod in front of the mount and push the brake pedal in direction of brake booster, so the ball head locates audibly.

-- Install the brake lamp sensor. Refer to BRAKE LAMP SENSOR, REMOVING AND INSTALLING .

-- Install the footwell vents -A-B-.

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- on the footwell vent.

-- Install the driver side instrument panel cover -1 to 3-.

Fig 4: Identifying Driver Side Instrument Panel Cover

Courtesy of AUDI OF AMERICA, LLC