LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Exterior Lights & Switches (Sedan)) >> 94 Exterior Lights, Switches >> Steering Column Switch Module >> Overview - Steering Column Switch Module >> Steering Column Electronics Control Module -J527-, REMOVING AND INSTALLING >> Installing

Steering Column Electronics Control Module -J527-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Make sure all retaining hooks and connectors are engaged securely.

-- Install the steering column trim panel. Refer to UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING and LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Install the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .

-- Install the driver airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

-- The steering angle sensor must be adapted in "Guided Fault Finding  " or "Guided Functions  " after replacing the return spring with slip ring using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals