LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Exterior Lights & Switches (Sedan)) >> 94 Exterior Lights, Switches >> Parking Aid >> Rear Parking Aid Sensor, Removing And Installing >> Installing

Rear Parking Aid Sensor, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Inner sensor - Sedan: 

-- Install the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

Vehicles with lane change assistance: 

If the bumper cover was removed, the Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770- must be calibrated again. Refer to LANE CHANGE ASSISTANCE, CALIBRATING .

Outer sensors: 

-- Install the lower section for the bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals