Parking Aid Control Module -J446-, REMOVING AND INSTALLING, VEHICLES WITH TRAILER HITCH: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Parking Aid Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Open the right luggage compartment side trim panel cover.

-- Remove the nuts -1- and -3-.

-- Disengage the electrical wire from the guides -arrows- on the retaining frame -2- and disconnect the cable tie -4-.

-- Remove the retaining frame upward.

-- Disconnect the connectors -2 through 4-.

Fig 2: Identifying Harness Connectors -2 Through 4-

Courtesy of AUDI OF AMERICA, LLC

-- Release the clip -arrow- and remove the Parking Aid Control Module -J446- -item 5- from the frame -1-.