Fog Lamp, Adjusting
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Checking and adjusting conditions
- Tire pressure is OK.
- The headlamp lens must be clean and dry.
- The headlamp lens may not be damaged.
- Headlamp-reflector and lamp are OK.
- Roll the vehicle several yards or move it back and forth several times to seat the springs.
- The parking brake must not be engaged so that the vehicle is not under stress.
- The vehicle and headlamp adjusting unit must be on a level surface.
- The headlamp adjusting unit must be aligned to the vehicle. Refer to the Headlamp Adjusting Unit Instructions.
- The inclination dimension is set on the headlamp adjusting unit. Refer to the Headlamp Adjusting Unit Operating Instructions.
- Vehicle load must be created.
Vehicle load on driver's seat in otherwise unloaded vehicle (curb weight).
- One person or 75 kg.
Procedure
-- The vehicle must be standing on a flat surface.
-- Turn the headlamp switch to "low beam" - not "Auto".
-- Pull the headlamp switch to "fog lamp".
Headlamp adjustment
-- To adjust headlamp range, turn the adjusting screw -arrow-.
- Angle dimension: 2%
NOTE:
The percentage indicator is based on a 10 meter projection distance. At an angle dimension of 2.0%, for example, converts to 20 cm.
Side adjustment is not intended.