Impact Absorber, Removing And Installing, Vehicles Through My 2012: Removing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing, bring all cable ties back to same positions.
Pry the impact bar out of the mounts if it is not easy to remove.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Disconnect the electrical connector -4- on the horns and free up the electrical wiring harness -3- on the horn bracket.
-- Free up the washer nozzle water drain hose by disconnecting the cable tie -1-.
-- Remove the bolts -arrows- and the bumper cover spacer -2-.
-- Remove the impact bar -5- from the mounts.