Removing and Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Headlamp Washer System Spray Nozzle Cover:

Removing

-- Fold the washer nozzle cover -1- upward in direction of -arrow A-.

-- Using a screwdriver on the inner side, pry the spray nozzle cover -1- off the mount -2- in direction of -arrow B- and disengage it at the opposite side.

Fig 1: Prying Off Spray Nozzle Cover

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order of removal. Note the following:

-- Press the spray nozzle cover on until it engages audibly.

Spoiler Lip:

Removing

-- Remove the expanding pin -3- with the expanding clip -2-.

-- Remove the spoiler lip -1-.

Fig 1: View Of Spoiler Lip Fasteners

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order of removal.

Front Bumper Cover End Plate:

Removing

-- Remove the bolts -1- and -2-.

-- Pull the front bumper cover end plate back.

Fig 1: Identifying Bolts & Front Bumper Cover End Plate

Courtesy of AUDI OF AMERICA, LLC

Installing

3 Nm

Install in reverse order of removal.