Roof End Strip, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
If the trim clamps remain in the body mounting points, remove them and insert them in the trim.
Check clamps for damage or deformation, replace if necessary.
-- Mount the rear roof panel trim -1- so that the hooks touch the D-pillar trim.
-- Position the rear roof panel trim on the pins, then press on it until the clips audibly engage.