LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Interior Trim (Sedan)) >> 70 Interior Trim >> Passenger Compartment Trim >> Sill Panel Strip, Removing And Installing >> Sill Panel Strip, Removing And Installing, Front Sill Panel >> Installing

Sill Panel Strip, Removing And Installing, Front Sill Panel: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Watch out for the following:

NOTE:

If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

Check clamps for damage or deformation, replace if necessary.

Driver Side:

-- Engage the front sill panel trim on the operating lever mount and push it into the foot compartment.

Front Passenger Side:

-- Slide the front sill panel trim guide into the carpet.

Procedure for Both Sides of Vehicle:

-- Clip the front sill panel trim onto the sill panel and stretch the door seal lip.