D-Pillar Trim Panel, Removing And Installing (AVANT): Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Do not pinch the head curtain airbag when installing the D-pillar trim.
Install in reverse order of removal. Note the following:
NOTE:
If the trim clamps remain in the body mounting points, remove them and insert them in the trim.
Check the clamps for damage or deformation and replace them if necessary.
-- First mount the D-pillar trim on the centering pins and then press until it engages audibly.
-- Pull the rubber lip of the luggage compartment seal over the edge of the trim.