B-Pillar Trim Panel, Removing And Installing, Upper B-Pillar Trim Panel: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Do not pinch the head curtain airbag when installing the B-pillar trim.
-- Guide the belt webbing and seat belt latch -2- in through the slide for the seat belt height adjuster.
NOTE:
Ensure that the seat belt height adjuster is in the bottom-most position.
-- Make sure the mount -3- for the sliding piece for the upper B-pillar trim -1- is securely latched into the retaining pins -4- on the seat belt height adjuster.
Installation is performed in reverse order of removal, while noting the following:
-- Install the front belt anchor. Refer to FRONT BELT END FITTING, REMOVING AND INSTALLING .
-- First install the B-pillar trim upward into the cut-out in the headliner and into the bracket.
-- Stretch the door seal lips over the trim panel.