LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Interior Trim (Sedan)) >> 70 Interior Trim >> Luggage Compartment Trim Panels >> Lock Carrier Trim Panel, Removing And Installing >> Lock Carrier Trim Panel, Removing And Installing (Sedan) >> Installing

Lock Carrier Trim Panel, Removing And Installing (Sedan): Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

Check clamps for damage or deformation, replace if necessary.

-- Guide the left and right rear cross panel trim retaining tabs in the openings on luggage compartment side trim -1-.

-- Insert the rear cross panel trim so that the left and right tabs engage in pins -3-.

-- Push on the rear cross panel trim until it engages audibly and stretch the lip of the rear lid seal over the rear cross panel trim.