Front Wheel Housing Liner, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Driveshaft Cover, Nuts And Wing Nut -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1-.

-- Remove the drive axle cover.

-- Remove the wing nut -2- on the left side of the vehicle and remove the expanding clip on the right side of the vehicle.

-- Remove the bolts -1-.

Fig 2: Removing Wheel Housing Liner

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -3- and remove the mount on the fender.

-- Remove the clips -2- and then remove the expanding clips from the wheel housing liner -4-.

-- To remove the clips -3-, unlock the release lever -2- with needle nose pliers in direction of -arrow A- and push it off the pin -1- in direction of -arrow B-.

-- Remove the wheel housing liner.

Fig 3: Identifying Clips -3-, Release Lever -2- And Pin -1-

Courtesy of AUDI OF AMERICA, LLC