Wheel Bearing Unit, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

Tightening specifications. Refer to OVERVIEW - WHEEL BEARING .

-- Install the drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Tighten the wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- On vehicles with automatic head lamp range control, perform headlamp basic setting. Refer to HEADLAMP, ADJUSTING .

-- If the Level Control System Sensor -- was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed using the Vehicle Diagnostic Tester. Refer to CONTROL POSITION, PROGRAMMING .

-- If the control position was reprogrammed on vehicles with lane assist, the Directional Stabilization Assistance Control Module -J759- must be calibrated again. Refer to LANE ASSIST, CALIBRATING .