Tower Brace, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Remove the bolt -1- and remove the E-box from the tower brace in the direction of the -arrow-.

Fig 1: Identifying Bolt And E-Box To Tower Brace

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector bracket on the bottom of the connector and push the connector toward the rear from the tower brace.

-- Remove the bolts -1- and nuts -2- and the tower brace -3-.

Fig 2: Identifying Bolts, Nuts And Tower Brace

Courtesy of AUDI OF AMERICA, LLC