SUBFRAME Heat Shield, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

Insert the square nuts into the cast recesses before installing the subframe shield. Refer to -item 16- "Square Nut" (See Figure).

Tightening specifications. Refer to OVERVIEW - SUBFRAME .