LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Interior Equipment (Sedan)) >> 68 Interior Equipment >> Storage Compartments And Covers >> Glove Compartment, Removing And Installing >> Installing

Glove Compartment, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Before handling pyrotechnic components and restraint systems (for example, connecting the electrical connector), the person handling them must "discharge static electricity". This can be done by touching the door striker, for example.
  • Make sure the connectors are installed correctly and are secure.

Install in reverse order of removal. Note the following:

-- Press the electrical connector together until it engages audibly.

-- Turn on the ignition.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to GROUND CABLE WITH Battery Monitoring Control Module -J367-, REMOVING AND INSTALLING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again.

scientia non olet · About LEMON Manuals