Windshield Wiper Arms, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the windshield wiper motor is to be run during the work procedure, the hood must be closed. Otherwise, the voltage supply of the wiper motor will be interrupted.

-- Bring windshield wiper into service position. Refer to WIPER, MOVING INTO SERVICE POSITION .

-- Turn off the ignition and remove the key.

-- Using a screwdriver, pry the caps -arrows- off the wiper arms -1-.

Fig 1: Identifying Nuts For Wiper Arms

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nuts -2- several turns.

-- Position the Puller - Wiper Arm Kit - Puller 1 T10369/1 on the wiper arm -1- as illustrated.

Fig 2: Identifying Windshield Wiper Arm And Puller T10369/1

Courtesy of AUDI OF AMERICA, LLC

-- Position the thrust piece -2- on the wiper axle.

-- Rotate the bolt -3- clockwise until the wiper arm is removed from the axle.

-- Remove nuts completely and remove wiper arms.