Wiper Arm, Adjusting
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
-- Position wiper arm with wiper blade installed at wiper axle and align wiper blade at rear window as follows:
- Dimension -a- = 19 + 5 mm.
NOTE:
The dimension is the gap between tip of wiper blade and lower edge of window.
-- Tighten the wiper arm nut.
- Tightening specification. Refer to OVERVIEW - REAR WINDOW WASHER SYSTEM .
-- Turn on the ignition.
-- Activate "rear wipe" and let the wiper arm run to end position.
-- Check the adjustment of windshield wiper arms again. If necessary correct.