Tank filling table

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Example:

If the fuel tank is half full, place a weight of 35 kg in the luggage compartment.

NOTE:

For additional weight use containers filled with water. A container filled with 5 liters of water weighs approx. 5kg.

Vehicle must be rolled for several meters or the front and rear suspension must be bounced several times so that the springs settle.

Vehicle and headlamp adjuster must be on a level surface operating instructions for headlamp adjuster.
Vehicle and headlamp adjuster must be aligned.

Ensure headlight adjuster is about 30 cm in front of headlight.

Inclination must be set.

Inclination measurements are stamped in "%" at top of headlamp. The headlamps must be adjusted according to these measurements. Percentage information is based on a projection distance of 10 meters. For example: inclination of 1.0 % converts to approx. 10 cm.

Vehicles with manual headlight range adjuster:

The headlight range adjuster thumb wheel must be in basic setting - 0 -.

Vehicles with automatic headlight range adjusting

NOTE:

To check/adjust headlights, they must always be placed in the basic setting with the VAS 5051.
Performing basic setting with VAS 5051 :
connect VAS 5051 with ignition switched off.

Fig 1: Connecting Diagnostic Lead Connector VAS 5051/1 Or VAS 5051/3 At Data Link Connector (DLC)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Use K-lead adapter VAS 6017B.
Switch ignition on.
Select "Guided Fault Finding"

Enter vehicle information; all control modules are interrogated.

Press the following selections in the order shown:

Go To
Functions and component selection
Body
Electrical Equipment

01 - On Board Diagnostic (OBD) capable systems
55-Dynamic Headlamp Range Control
J 431-Dynamic Headlamp Range Control, Functions
J 431-Headlamp Range Control Module, basic setting

Press button

Follow the steps of the tester and confirm the entry until the following text appears:

J 431-Headlamp Range Control Module, basic setting

Press button
Follow test sequence