Perform battery load test
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Switch ignition off.
- Read battery tester operating instructions.
- Connect test lead clamps to battery terminals as shown in battery tester operating instructions.
The clamps must make good contact with battery poles.
- Load current depends on battery capacity and must be adjusted on the tester battery tester operating instructions.
- Perform battery load test according to operating instructions.