Wiper blade park position, rear window

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Let wiper motor run to end position.
Switch ignition off and remove ignition key.

Fig 1: Identifying Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully spread cover - arrows - and lift.

Fig 2: Identifying Spray Jets And Hex Head Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Carefully remove spray jets - 2 -.
Loosen hex head nuts - 1 - a few turns.
Loosen wiper arms by tilting wiper shaft slightly.

Fig 3: Identifying Dimensions For Wiper Blade On Rear Window

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place wiper blade on rear window and adjust as follows:

Dimension - a - = 15 to 20 mm

NOTE:

Dimension gives distance of wiper blade point to lower edge of window.
Tighten wiper arm nut to 12 Nm.
Activate wiper.
Adjust wiper arm again, if necessary, and tighten nut.
Check spray jet adjustment → Windshield washer system: Checking nozzle setting, adjusting nozzles if necessary .