8-cyl. engines 4.2L (RS4)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Switch ignition off.
Right cylinder bank
- Remove upper part of air filter → Air cleaner: Clean air filter housing and replace filter .
- Remove both bolts - 1 -.
- Push connector - 2 - toward ignition coil, press on catch with hand and remove connector.
- Remove ignition coil - 3 - from spark plug using Ignition Coil Puller T40039.
- Remove spark plugs using spark plug wrench T40039.
- Install new spark plugs.
| Tightening torque | Nm |
|---|---|
| Spark plugs in cylinder head | 30 |
NOTE:
- Push ignition coils by hand into intended resources in cylinder head cover.
Left cylinder bank
- Remove coolant reservoir -arrow-.
- Tie aside coolant reservoir with coolant hoses 1 to 3 connected.
- Remove both bolts - 1 -.
- Push connector - 2 - toward ignition coil, press on catch with hand and remove connector.
- Remove ignition coil - 3 - from spark plug using Ignition Coil Puller T40039.
- Remove spark plugs using spark plug wrench T40039.
- Install new spark plugs.
| Tightening torque | Nm |
|---|---|
| Spark plugs in cylinder head | 30 |
NOTE:
- Push ignition coils by hand into intended resources in cylinder head cover.