Battery: Ensure battery cable fits securely
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Check battery terminals on vehicle battery for secure fit, tighten nuts on -terminal -1- and + terminal - 2 - if necessary.
WARNING:
If the battery clamp is not seated securely on the positive terminal, disconnect battery Ground (GND) strap on battery negative terminal first, to prevent possible accidents.
NOTE:
- Observe before disconnecting battery → Note before disconnecting battery. .
- Check battery for secure fit, tighten screws - 4 - on securing bracket - 3 - if necessary.
| Tightening torque | Nm |
|---|---|
| Battery connection to battery terminal | 6 |
| Screw to securing bracket | 12 |