Primary Connector with Special Connector Systems

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

NOTE:

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts → Secondary Lock .

Fig 1: Removing Fasten Connector Terminal (1 Of 2)

GW00004288

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fasten contacts:

Guide release tool (that fits terminal housing) into release channel on terminal housing - arrow -.

Grasp contact at wire and push gently into terminal housing.

NOTE:

By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using release tool.

Fig 2: Removing Fasten Connector Terminal (2 Of 2)

GW00004329

Courtesy of VOLKSWAGEN UNITED STATES, INC.

At the same time, push release tool in direction of terminal housing and pull released contact out of terminal housing - arrow -.

Remove release tool after removing contact from housing.

Fig 3: Removing GT 150/280 Connector Terminal (1 Of 2)

GW00004330

Courtesy of VOLKSWAGEN UNITED STATES, INC.

GT 150/280 contacts:

Guide release tool (which fits terminal housing) under retaining tab into terminal housing.

Push tool into terminal housing until it stops - arrow -.

Fig 4: Removing GT 150/280 Connector Terminal (2 Of 2)

GW00004331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Contact is ejected from the terminal housing.

Remove release tool after removing contact from housing.

Fig 5: Removing Connector Terminal Without Releasing Tabs (1 Of 2)

GW00004332

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Contacts without retaining tabs:

Insert release tool under retaining tab of terminal housing.

Push release tool through until it stops by gently lifting - arrow -.

Fig 6: Removing Connector Terminal Without Releasing Tabs (2 Of 2)

GW00004333

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Contact is ejected from terminal housing.

Remove release tool after removing the contact from housing.