Fuse box, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove driver's storage compartment:

Refer to 68 - INTERIOR EQUIPMENT

Fig 1: Identifying Bolts For Fuse Box

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -1- for fuse box-2-.
Remove fuse box from center tube for instrument panel.
Detach wiring harness on center tube for instrument panel and set aside.

Fig 2: Fuse Panel Cover And Cable Tie

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Cut cable tie -1-.
Release cover for fuse box -arrows-.
Pull fuses from fuse box.

Fig 3: Removing Retaining Strip For Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull off retaining strip for connectors -arrows- and remove connectors from fuse box.
Unclip base -1-.

NOTE:

Fig 4: Identifying Main Fuse Panel

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Check the exact assignment for fuse carrier in the current wiring diagram.

Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations

Installing

Installation is reverse of removal, paying attention to the following:

NOTE: All cable ties opened or cut during removal must be reinstalled at the same locations during installation.

Tightening torque

Component	Nm
Fuse box to center tube for instrument panel	3