Window regulator switch, removing and installing
WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The driver's side window regulator switch is depicted in the illustration.
- Passenger's side window regulator switch is removed in the same manner.
Removing
Fig 1: Pressing Back Retaining Tab Of Window Regulator Switch And Removing Switch Upward From Armrest
- Position a flat screwdriver at the armrest hole as depicted in the illustration.
- Press back retaining tab of window regulator switch -arrow- and remove switch upward from armrest.
- Disconnect connector.
- Carefully release catches -arrows- using a small screwdriver.
- Remove window regulator switch -1- downward from switch mount -2-.
Installing
Installation is reverse of removal, paying attention to the following:
- Press window regulator switch into switch mount until catches engage.