Switch for convertible top operation/navigation, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Pull up parking brake lever.

Fig 1: Unclipping Cover Below The Parking Brake Lever At Mounting Springs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip cover -2- below the parking brake lever at mounting springs -1-.

Fig 2: Pressing Out Convertible Top Operation Switch/Navigation From Center Console

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Grasp opening below parking brake lever and from bottom, press out Convertible Top Operation Switch/navigation from center console -arrows-.

Fig 3: Identifying Electrical Harness Connectors, Catches, Navigation Switch, And Mounting Frame

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical harness connectors -3 to 6-.
Carefully release catches -arrows- using a small screwdriver.
Remove Navigation switch -1- from mounting frame -2-.

Installing

Installation is the reverse of removal.