Headlights, removing and installing:: Removing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Switch ignition off and remove ignition key.
Turn light switch into -0- position.

Left headlight:

Fig 1: Removing Cover In Engine Compartment (Left Side)

GW00017583

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove cover -1- in engine compartment (left side).

Right headlight:

Fig 2: Removing Cover In Engine Compartment (Right Side)

GW00017582

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove cover -1- in engine compartment (right side), if present.

Fig 3: Evaporative Emission Canister Purge Regulator Valve N80 And Air Duct

GW00004732

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -arrows-.
Detach Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- -1- at air guide.
Remove air duct -2-.

Continuation for both sides:

Apply adhesive tape below the headlight to protect the paint.

Fig 4: Identifying Electrical Harness Connector And Bolts

GW00021848

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -1- and -4-.
Loosen screw -2- several turns but do not remove completely.
Cut cable tie if present.
Disconnect electrical harness connector -3-.

Fig 5: Removing Headlight From Body Toward Front

GW00021849

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Swing headlight in direction of fender.
Remove headlight from body toward front.