Headlights, removing and installing:: Installing
WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Installation is reverse of removal, paying attention to the following:
- Push headlight horizontally up to stop on bottom headlight mount.
- Align headlight to contours of body (gap widths).
NOTE:
Note area of fender panel cut out when aligning headlight.
- Tighten bolts -1-, -2- and -4-.
- Adjust headlight after installing. Refer to Headlights, adjusting .
Tightening torque
| Component | Nm |
| Headlights to lock carrier | 6 |