Fog lights, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Switch ignition off and remove ignition key.
Turn light switch into -0- position.

Fig 1: Releasing Catches Using Screwdriver And Removing Air Intake Grille On Left/Right On Bottom Part Of Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disengage catches -1- to -4- using a screwdriver -arrow- and pull off air inlet grid in lower part of bumper.

Fig 2: Identifying Bolts For Headlight Insert

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -arrows-.
Remove headlight insert.
Unplug connector.

Installing

Installation is reverse of removal, paying attention to the following:

Adjusting fog lights. Refer to Fog light, adjusting .

Tightening torque

Component		Nm
Fog light housing to bumper		5