Spray jets, removing and installing

WARNING: This page is about a different car, the 2002 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Switch ignition off and remove ignition key.

Fig 1: Unclipping Base Of Spray Jet From Bottom Of Hood

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip base of spray jet from bottom of hood -arrow-.
Disconnect washer fluid hose from unclipped spray jet.
Disconnect electrical harness connector, if present.

Installing

Installation is reverse of removal, paying attention to the following:

NOTE: Washer fluid hose must engage audibly into connection for spray jet.