"Symphony ll" radio, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools and Equipment

Fig 1: Identifying Special Tools - Radio Removal Tool T10057

Courtesy of VOLKSWAGEN UNITED STATES, INC.

T10057 radio removal tool

Removing

Fig 2: Pushing Four Clips Of Radio Removal Tool T10057 Into Front

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push the four clips of radio removal tool T10057 into the front.
Pull the radio out of the instrument panel.
Unplug the connectors and the antenna wire.
Pull out the release tool from the radio - to do this, press in the locking tabs at the top and bottom on the radio.

Installing

Plug in the connectors and the antenna wire.
Carefully insert the radio into the instrument panel and let it engage in the installation slot.
Perform coding if the radio was replaced.

Do this using vehicle diagnostic, testing and information system VAS 5051.