Function Selector Switch II -E272-, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Pull up parking brake lever.

Fig 1: Unclipping Cover Below The Parking Brake Lever At Mounting Springs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip cover -2- below the parking brake lever at mounting springs -1-.

Fig 2: Pressing Out Convertible Top Operation Switch/Navigation From Center Console

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Grasp opening below parking brake lever and press Convertible Top Operation Switch/navigation out of center console from bottom -arrows-.

Fig 3: Identifying Electrical Harness Connectors, Catches, Navigation Switch, And Mounting Frame

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical harness connectors -3 to 6-.
Carefully release catches -arrows- using a small screwdriver.
Remove Function Selector Switch II position 1 from mounting frame -2-.

Installing

Installation is the reverse of removal.