Control module for navigation with CD-mechanism -J401-, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools and Equipment

Fig 1: Identifying Special Tools - Radio Removal Tool T10057

Courtesy of VOLKSWAGEN UNITED STATES, INC.

T10057 radio removal tool

Removing

Open lid in left luggage compartment side trim.

Fig 2: Insert Two Hooks Of T10057 Radio Removal Tool Into Front Of Control Module For Navigation With CD Drive

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert two hooks of T10057 radio removal tool into the front of Control module for navigation with CD drive -2-.

Top L - left top
Top R - right top

Pull Control module for navigation with CD-mechanism out of mounting frame -1-.
Disconnect electrical harness connectors and antenna wire at rear of control module for navigation with CD-mechanism.
Remove radio removal tool from control module for navigation with CD-mechanism, press locking latches at control module to do so.

Installing

Installation is the reverse of removal, paying attention to the following:

NOTE:

After installation of a new control module for navigation, the navigation must remain switched on for a specific time so that the system data of the respective satellites can be loaded. This procedure should be performed outdoors and can last up to 20 minutes. Only following this is the navigation useable.