Vehicle Electrical System Control Module J519 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Should Vehicle Electrical System Control Module J519 require replacement, follow replacement procedures as specified using VAS 5051/5052 in mode "Guided Fault Finding".

Removing

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Where applicable, remove drivers storage compartment → 68 - INTERIOR EQUIPMENT .

Fig 1: Identifying Nuts And Vehicle Electrical System Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove nuts - arrows - and remove Vehicle Electrical System Control Module J519 - 1 -.

Fig 2: Identifying Fuse Carrier And Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip fuse carriers - 1... 3 -.
Release retaining clip at connector - 4 - and disconnect connector.
Disconnect electrical connections - 5 - and - 6 -.

Installing

Install in reverse order of removal, noting the following:

Install drivers storage compartment → 68 - INTERIOR EQUIPMENT .

Tightening torque

Component - fastener	Nm
Control module to central tube for instrument panel - nut	2.4