Electronics box in plenum chamber, removing and installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove rubber seal of plenum chamber cover in direction of - arrow -.
- Remove plenum chamber cover - 1 - to front.
- Use screwdriver to pry off the two caps - 3 -.
- Loosen nuts - 4 - (do not remove).
- Remove wiper arms - 2 - from wiper shaft by tilting slightly.
- Remove nuts completely and remove wiper arms.
- Pull off retaining clips - 1 - and detach cowl panel grille - 5 -.
- Remove cover for electronics box in plenum chamber - arrows -.
- Use screwdriver to pry off retaining strap - arrows -.
- Release connector locks tabs - arrows - and disconnect electrical connections - 1 - and - 2 - for Motronic Engine Control Module (ECM) J220 (where applicable).
- Where applicable, release retaining clip for transmission control module.
- Release connector lock - arrow - and disconnect from transmission control module.
- Disconnect electrical connections - 2 - at rear of connector console.
- Remove wire - 1 -.
- Release retaining clips - arrows - and lift auxiliary relay carrier out of electronics box.
- Remove the engine wiring harness at electronics box and bulkhead and set aside.
- Remove nuts - arrows -.
- Lift electronics box and remove upwards.
Installing
Install in reverse order of removal.
Tightening torque
| Component | Nm |
| Plenum chamber electronics box to body | 3 |