Comfort System Central Control Module J393 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove A-pillar trim: → 70 - INTERIOR TRIM .
Remove drivers seat → 72 - SEAT - FRAMES .

NOTE:

Safety belts at seat frame do not have to be unfastened.
Fold back floor covering.

Fig 1: Identifying Cover For Drivers Side Electronics Box

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release cover for electronics box (drivers side) - arrows - and fold cover towards right.

Fig 2: Identifying Retaining Clips, Comfort System Central Control Module J393, And Electrical Connections

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining clips - arrows - and remove Comfort System Central Control Module J393 - 1 - from electronics box.
Disconnect electrical connections - 2... 6 -.

NOTE:

Refer to the applicable wiring diagram for exact identification of connections on electronics box Wiring Diagrams.

Installing

Install in reverse order of removal, noting the following:

Install A-pillar trim: → 70 - INTERIOR TRIM .
Install drivers seat → 72 - SEAT - FRAMES .