Parking Aid Control Module J446 , removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Location: At left rear or luggage compartment below side trim/taillamp.

Remove left luggage compartment side trim → 70 - INTERIOR TRIM .

Sedan:

Fig 1: Removing Screws And Base Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows - and remove base mount - 1 -.

Fig 2: Disconnecting Electrical Connections And Antenna Wiring At Rear Of Navigation Interface

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Where applicable, disconnect electrical connections and antenna wiring at rear of Navigation Interface R94 - 1 -.

NOTE:

Disregard - 2 -.

Avant:

Fig 3: Removing Screws And Base Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows - and remove base mount - 1 -.

All:

Fig 4: Identifying Electrical Connections, Screws, And Parking Aid Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connections - 2 - and - 3 -.
Remove screws - arrows -.
Remove Parking Aid Control Module J446 - 1 -.

NOTE:

Sedan installation is illustrated.

Installing

Install in reverse order of removal.

Tightening torque

Component - fastener	Nm
Parking Aid Control Module J446 to body - screw	1.8